HIKVISION DS-2 Series User Manual

User Manual of 5-inch Smart Speed Dome
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
12
(3) Click the up/down direction buttons to increase/decrease the value.
(4) Click IRIS+ button to confirm and exit.
Y - M - D 07 01 18
H - M - S 15 33 25
DONE: OPEN
QUIT: CLOSE
Figure 3-4 Set the System Time
 Zero angle (initial position) configuration
Purpose:
You can define the initial position in the panning direction on the ZERO ANGLE submenu.
Steps:
1. Move the cursor to ZERO ANGLE using the direction buttons and click IRIS+ to enter.
2. Click the left/right/up/down direction buttons to adjust the view angle.
3. Click IRIS+ button to confirm and exit.
 Fan parameter configuration
You can set the FAN CONTROL as ON or OFF.
 EIS (Electronic Image Stabilization) configuration
You can set the EIS FUNCTION as ON or OFF; and set the EIS LEVEL as 0-3.
Note: The selectable EIS levels vary depending on the camera models.
 Preset direct focus
You can set the preset direct focus function ON/OF on PRESET DFOCUS submenu.
 Protocol settings
You can set the PROTOCOL STATUS SET as ON or OFF, and set the PROTOCOL SET as AUTO
MATCH, PELCP-P, PELCO-D, Private-code, etc.
 RS-485 checksum setting
You can set the 485CHECK SET as ON or AUTO for improving the controlling effect.
 Power Off Memory
You can set the duration of Power Off Memory as 30s, 60s or 180s for power off memory.

HIKVISION DS-2 Series Specifications

General

Brand	HIKVISION
Model	DS-2 Series
Category	Security Camera
Language	English