User Manual of Network Mini PTZ Camera
© Hikvision
6.2 Configuring Basic PTZ Parameters
Purpose:
You can configure the basic PTZ parameters, including proportional pan, preset
freezing, preset speed, etc.
1. Enter the Basic PTZ Parameter Configuration interface:
Configuration > Advanced Configuration > PTZ > Basic
Figure 6-2 Basic PTZ Configuration Interface
2. Configure the following settings:
Basic Parameters: Enable/disable proportional pan and preset freezing, set the
preset speed, and keyboard control speed.
Proportional Pan: If you enable this function, the pan/tilt speeds change
according to the amount of zoom. When there is a large amount of zoom, the
pan/tilt speed will be slower for keeping the image from moving too fast on
the live view image.
Preset Speed: You can set the speed of a defined preset from 1 to 8.
Keyboard Control Speed: Define the speed of PTZ control by a keyboard as
Low, Normal or High.
Manual Control Speed: The manual control speed can be set as Compatible,
Pedestrian, Non-motor Vehicle, Motor Vehicle or Self-adaptive.
Compatible: The control speed is same as the Keyboard Control Speed.
Pedestrian: Choose the Pedestrian when you monitor the pedestrians.
Non-motor Vehicle: Choose the Non-motor Vehicle when you monitor the
non-motor vehicles.
Motor Vehicle: Choose the Motor Vehicle when you monitor the motor
vehicles.
Self-adaptive: You are recommended to set the Self-adaptive when the
To Next Page
Loading...
Need help?
General
Weight and Dimensions
