HIKVISION DS-3E2300P Series Quick Start Guide

16/24-Port 100M Long-Range PoE Switch Quick Start Guide
10
Step 1 Connect the two paired SFP optical module with an optical fiber.
Step 2 Hold SFP optical module from one side, and smoothly plug it into the switch along with the
SFP port slot until optical module and the switch are closely attached.
Step 3 After powering on your switch, check the status of Link/Act indicator. If the indicator is lit,
the link is connected. If the indicator is unlit, the link is disconnected. Check the line, and
make sure opposite devices have been started. For more details, see section Indicator.
3.3 Checking the Cabling
Before powering your switch, make sure that:
 The operating power supply is compliant with rated input standard.
 Port cables and grounding cables are correctly connected.
 If there is outdoor cabling, connect a lightning rod and lightening arrester to the cable.
Figure 3-2 Lightning Rod Connection
3.4 Powering on Switch
Please use the attached power cord to power up the switch.

HIKVISION DS-3E2300P Series Specifications

General

Brand	HIKVISION
Model	DS-3E2300P Series
Category	Switch
Language	English