EasyManuals Logo
Home>HIKVISION>DVR>DS-7316HWI-SH

HIKVISION DS-7316HWI-SH User Manual

HIKVISION DS-7316HWI-SH
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Quick Operation Guide of DS-7200-SH/SV/SL and DS-7300/8100-SH Series DVR
1
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact
dealer.
This manual is applicable to the following models:
Type Model
Network HDVR
DS-7204HFI-SH, DS-7208HFI-SH, DS-7216HFI-SH
DS-7204HWI-SH, DS-7208HWI-SH, DS-7216HWI-SH
DS-7204HVI-SV, DS-7208HVI-SV, DS-7216HVI-SV
DS-7208HWI-SL, DS-7216HWI-SL
DS-7304HFI-SH, DS-7308HFI-SH, DS-7316HFI-SH
DS-7304HWI-SH, DS-7308HWI-SH, DS-7316HWI-SH
Network DVR
DS-7204HVI-SH, DS-7208HVI-SH, DS-7216HVI-SH
DS-7204HWI-SV
DS-7224HVI-SH, DS-7232HVI-SH
DS-7224HWI-SH, DS-7232HWI-SH
DS-7324HFI-SH, DS-7332HFI-SH
DS-7324HWI-SH, DS-7332HWI-SH
DS-7324HI-SH, DS-7332HI-SH
DS-8124HCI-SH, DS-8132HCI-SH
DS-8124HFSI-SH, DS-8132HFSI-SH
DS-8124HWSI-SH, DS-8132HWSI-SH
DVR Pre-Installation
This Series DVR is highly advanced surveillance equipment that should be installed with care. Please take into
consideration the following precautionary steps before installation of the DVR.
1. Keep all liquids away from the DVR.
2. Install the DVR in a well-ventilated and dust-free area.
3. Ensure environmental conditions meet factory specifications.
4. Install a manufacturer recommended HDD.
DVR Installation
During the installation of the DVR:
1. Use brackets for rack mounting.
2. Ensure there is ample room for audio and video cables.
3. When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4. Connect both the alarm and RS-485 cable.
5. Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
6. Ensure the DVR is grounded.
7. Environmental temperature should be within the range of -10 ºC ~ 55 ºC, 14ºF ~ 131ºF.
8. Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Before you start:
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the DVR. A factory
recommended HDD should be used for this installation.
Tools Required: Screwdriver.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-7316HWI-SH and is the answer not in the manual?

HIKVISION DS-7316HWI-SH Specifications

General IconGeneral
Product colorBlack
Channels quantity16 channels
Maximum frame rate30 fps
Total storage capacity12000 GB
Video compression formatsH.264
Playback resolutions supported1920x1080, 1280x1024, 1280x720, 1024x768, 704x576, 704x480
Audio input4
RS-485 ports1
BNC input ports16
BNC output ports2
USB 2.0 ports quantity3
Ethernet interface typeGigabit Ethernet
HDD interfaceSerial ATA
Maximum HDD capacity4000 GB
Power requirements100-240 VAC, 5A, 50-60Hz
Power consumption (typical)35 W
Operating temperature (T-T)-10 - 55 °C
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Dimensions (WxDxH)445 x 390 x 70 mm

Related product manuals