Quick Operation Guide of DS-7200-SH/SV/SL and DS-7300/8100-SH Series DVR
4
Front Panel
DS-7200-SH/SV/SL:
The front panel of DS-7200 series DVR is shown below:
Table 1 Description of Control Panel Buttons
No. Name Function Description
POWER indicator turns green when DVR is powered up.
STATUS indicator lights in red when data is being read from or written to HDD.
Tx/Rx indictor blinks green when network connection is functioning properly.
4 USB Interface Connects USB mouse or USB flash memory devices.
5 IR Receiver Receiver for IR remote.
DS-7300-SH:
The front panel of DS-7300-SH is shown below:
Table 2 Description of Control Panel Buttons
No. Name Function Description
1 POWER ON/OFF Power on/off switch.
2 IR Receiver Receiver for IR remote control.
3 USB Connect to USB mouse or USB flash memory devices.
4 DVD-R/W Slot for DVD-R/W.
POWER Power indicator lights in green when DVR is powered up.
READY Ready indicator is normally green, indicating that the DVR is functioning properly.
Indicator turns green when DVR is controlled by an IR remote control with the
Indicator turns red when the SHIFT button is used;
Indicator does not light when the DVR is controlled by a keyboard or by the IR
remote control with the address of 255;
Indicator turns green when the DVR is controlled by IR remote control (with the
address from 1~254) and keyboard at the same time , and the SHIFT button is not
Indicator turns orange : (a) when the DVR is controlled by IR remote control (with
the address from 1~254) and keyboard at the same time and the SHIFT button is used
as well; (b) when the DVR is controlled by IR remote control (with the address from
1~254) and the SHIFT button is used.
ALARM Alarm indicator turns red when a sensor alarm is detected.
HDD HDD indicator blinks in red when data is being read from or written to HDD.
TX/RX indictor blinks in green when network connection is functioning properly.