User Manual of DS-9600/8600/7700/7600 Series NVR
163
9.4 Configuring Network Detection
Purpose:
You can obtain network connecting status of NVR through the network detection function,
including network delay, packet loss, etc.
9.4.1 Testing Network Delay and Packet Loss
Steps:
1. Enter the Network Traffic interface.
Menu >Maintenance>Net Detect
2. Click the Network Detection tab to enter the Network Detection menu, as shown in Figure
9. 26.
Figure 9. 26 Network Detection Interface
3. Enter the destination address in the text field of Destination Address.
4. Click to start testing network delay and packet loss. The testing result pops
up on the window. If the testing is failed, the error message box will pop up as well. Refer
to Figure 9. 27.
Figure 9. 27 Testing Result of Network Delay and Packet Loss
9.4.2 Exporting Network Packet
Purpose:
By connecting the NVR to network, the captured network data packet can be exported to
USB-flash disk, SATA/eSATA CD-RW and other local backup devices.
Steps:
1. Enter the Network Traffic interface.
Menu >Maintenance>Net Detect
2. Click the Network Detection tab to enter the Network Detection interface.
To Next Page
Loading...
Need help?
General
