Digital Video Recorder User Manual
50
safety and reliability.
Before You Start
You must set the storage mode to Group before you set the HDD property to Redundancy. For
detailed information, refer to Configure HDD Group. There should be at least another HDD which
is in Read/Write status.
Steps
1. Go to Storage → Storage Device.
2. Select a HDD from the list and click to enter the Local HDD Settings interface.
3. Set the HDD property to Redundancy.
4. Go to Storage → Schedule Settings → Record Schedule/Capture Schedule.
5. Click Advanced to set the camera recording parameters.
Figure 4-4 Record Parameters
6. Check Redundant Record/Capture.
To Next Page
Loading...
Need help?
General