Quick Start Guide of Digital Video Recorder
25
2. Click Logout.
Using the Setup Wizard
The Setup Wizard can walk you through some important settings of the device. By default, the Setup Wizard starts
once the device has loaded.
Operating the Setup Wizard:
1. Select the system resolution from the dropdown menu. The default resolution is 1280×1024/60Hz.
Click Apply to save the resolution settings.
2. Check the checkbox to enable Setup Wizard when device starts. Click Next to continue the setup wizard.
Follow the guide of the Setup Wizard to configure the system resolution, system date/time, network settings,
HDD management, record settings, etc.
Network Settings
Purpose:
Network settings must be properly configured before you operate DVR over network.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
To Next Page
Loading...
Need help?
General