Quick Start Guide of Digital Video Recorder
6
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.
This manual is applicable to the models listed in the following table.
DS-7204HFHI-SL
DS-7208HFHI-SL
DS-7204HFHI-SE
DS-7208HFHI-SE
DS-7204HFHI-ST
DS-7208HFHI-ST
DS-7304HFHI-SL
DS-7308HFHI-SL
DS-7316HFHI-SL
DS-7304HFHI-ST
DS-7308HFHI-ST
DS-7316HFHI-ST
DS-8104HFHI-SL
DS-8108HFHI-SL
DS-8116HFHI-SL
DS-8104HFHI-ST
DS-8108HFHI-ST
DS-8116HFHI-ST
DVR Installation
During the installation of the DVR:
1. Use brackets for rack mounting.
2. Ensure there is ample room for audio and video cables.
3. When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4. Connect both the alarm and RS-485 cable.
5. Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
6. Ensure the DVR is grounded.
7. Environmental temperature should be within the range of -10 ºC ~ 55 ºC , 14ºF ~ 131ºF.
8. Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Before you start:
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the DVR. A factory
recommended HDD should be used for this installation.
Up to 8 SATA hard disks can be installed on your DVR.
Tools Required: Screwdriver.
As the installation steps of HDD are similar among different models, here we take the steps of the
DS-7200HFHI-SE as an example.
Steps:
1. Remove the cover from the DVR by unfastening the screws on the back and side.
To Next Page
Loading...
Need help?
General