Digital Video Recorder User Manual
117
8.2 Setting PIR Camera Alarm
Purpose
DVR can receive the PIR (Passive Infrared) alarm of the analog cameras supporting the function via
coaxial communication. You can enable false alarm filer for the motion detection of the PIR
cameras. Then only when the motion detection events and PIR events are both triggered, the motion
detection alarm will be triggered, and the alarm indicator will light on for the PIR cameras
supporting enabling alarm indicator.
Before you start
Connect the PIR camera to the DVR. Configure White Light as Alarm and Trigger Mode as DVR
for the camera OSD.
Step 1 Go to Menu > Camera > Motion.
Figure 8-5 Motion Detection
Step 2 Select the connected PIR camera.
Step 3 Check Enable Motion Detection.
Step 4 Check False Alarm Filter to enable PIR motion detection. The message box pops up as
below.
Figure 8-6 Note
Step 5 Click OK to enable PIR motion detection. Then only when the motion detection events and
PIR events are both triggered, the motion detection alarm will be triggered.
To Next Page
Loading...
Need help?
General
