Digital Video Recorder User Manual
47
Aux/Main Monitor: the DVR checks the connection of the output interfaces to define the main
and auxiliary output interfaces. When the aux output is enabled, the main output cannot do any
operation, and you can do some basic operation on the live view mode for the Aux output.
For DVR with CVBS output, the VGA/HDMI output is the main output, and the CVBS output is
the aux output. The priority relationship is shown as Table 3-2.
Table 3-2 Priorities of Outputs
√ means the interface is in use, × means the interface is out of use or the connection is invalid. And the
HDMI, VGA and CVBS can be used at the same time.
3.2.1 Using the Mouse in Live View
You can refer to Table 3-4 for the description of mouse operation in live view mode.
Table 3-3 Mouse Operation in Live View
Enter the main menu of the system by right clicking the
mouse.
Switch to the single full screen by choosing channel number
from the drop-down list.
Adjust the screen layout by selecting from the drop-down list.
Switch to the previous screen.
Switch to the next screen.
Enable/disable the auto-switch of the screens.
The dwell time of the live view configuration must be set before using
Start Auto-Switch.
Start recording of all channels, Continuous Record and Motion
Detection Record are selectable from the drop-down list.
A shortcut to enter the IP camera management interface.(For
To Next Page
Loading...
Need help?
General
