HIKVISION iDS-2CD9396-AIS User Manual

Network Traffic Camera • User Manual
48

Control Flash Light according to Brightness of the License Plate is only available when you
set the effective status as Pulse.

Control Flash Light according to Time Schedule is recommended.
 Polarize Mode
1) Enable polarizer according to the actual environment.
− Enable Polarizer by Brightness: Set the brightness threshold from 0 to 100, and the
polarizer takes into effect when the brightness comes to the threshold.
− Enable Polarizer by Schedule: Set the start time and end time. The polarizer takes into
effect according to the time schedule you configured.
(Optional) Check the channel No. to copy the same settings to other channels.
Click Save to save the settings.
IO:3 is built-in flash light.
Configure Traffic Light Synchronization
Go to Configuration> Device Configuration > Capture Parameters > Traffic Light
Synchronization.
Configure Traffic Light Synchronization
Check Enable Traffic Light Synchronization, to adjust the camera phase position in sync.
with that of flash light.
Enter Phase Position to adjust flash light brightness. It ranges from 0 to 360.
Select Signal Frequency according to actual power supply frequency.
Click Save to save the settings.

HIKVISION iDS-2CD9396-AIS Specifications

General

Brand	HIKVISION
Model	iDS-2CD9396-AIS
Category	Security Camera
Language	English