User Manual of DS-6700 Series Audio/Video Encoder
55
8.2 Configuring Video Settings
Steps:
1. Click Remote Configuration > Camera Settings >Video Settings to enter the Video Settings interface:
Figure 8.7 Video Settings
2. Select the camera from the drop-down list to configure.
3. Select the Stream Type of the camera to Main Stream (Normal), Main Stream (Event) or Sub Stream.
The main stream is usually for recording and live viewing with good bandwidth, and the sub stream can be
used for live viewing when the bandwidth is low. Refer to the Chapter 7.1 Local Configuration on changing
the main stream to sub stream for live viewing.
4. You can customize the following parameters for the selected Main Stream or Sub Stream:
Video Type: Select the video type to video stream, or video & audio composite stream. The audio signal
will be recorded only when the Video Type is Video & Audio.
Resolution: Select the resolution of the video input.
Bitrate Type: Select the bitrate type to constant or variable.
Video Quality: When bitrate type is selected to Variable, 6 levels of video quality can be configured.
Frame Rate: Set the frame rate to 1~30 fps.
The frame rate used to describe the frequency at which a video stream is updated is measured in frames per
second (fps). A higher frame rate is advantageous when there is movement in the video stream, as it
maintains image quality throughout.
Max. Bitrate: Set the Max. bitrate to 32~8192 Kbps.
I Frame Interval: Set the I frame interval to 1~ 400 (frames). The higher value results in lower video
quality.
Video Encoding: Select the video encoding standard to H.264, MPEG2, MPEG4 or MJPEG.
Note: When the MJPEG video encoding standard is selected, the frame rate can be set to 1~15fps and the
max. bitrate is not configurable.
5. If you want to copy the display settings of the current camera to other cameras, spread the Copy to Camera
To Next Page
Loading...
Need help?
General
