Hisense k560 User Manual

13
Basic Features
1. Make sure that you have:
Installed the remote control batteries.
Connected an antenna or cable.
Connected the power cord.
Matched the remote control with TV.
2. Press [POWER
] button to turn on your TV. The Setup
Wizard menu displays.
3. Press [▲/
▲
/
▲
/
▲
] to select your menu language: English,
Spanish or French, press [ENTER] button to confirm.
4.
Press [▲/
▲
] to select your Picture Mode: Home Mode or
Retail Mode, press [ENTER] button to confirm.
If you select Retail Mode, a message appears “Are you
sure you want retail mode?” Select “Yes” to continue, or
select “No” to change your selection.
IMPORTANT: At first, you have to match the remote
control with TV.
To turn your TV on or off (standby mode):
1.
Plug the power cord into an AC power outlet.
2.
Press [POWER] button, Your TV turns on.
3.
Press [POWER] button again to turn off your TV. When
you turn off your TV, it goes into standby mode.
The Setup Wizard menu appears the first time you turn
on the TV. It will assist you to specify the menu language,
Picture Mode, Tuner Mode and Channel Installation.
IMPORTANT: Make sure that the antenna or cable is
connected and a wired or wireless Internet connection is
available.
Turning the TV On for the First Time
Turning the TV on or off
If you selected Retail Mode, Energy Saving is not
realized.
5. Press [▲/
▲
] to select your Tuner Mode: Antenna or
Cable, press [ENTER] button to confirm.
6. Press [▲/
▲
] to set the Channel Installation: Scan or Skip
Scan, press [ENTER] button to confirm.
If you select “Scan”, your TV automatically starts Channel
Installation available in your viewing area.
If you select “Skip Scan”, your TV does not scan for
channels.
Depending on the reception condition, it may take up to
25 minutes or more to complete memorizing channels.
Please allow the process to complete without interruption.
WARNING
When your TV is in standby mode, it is still receiving
power. To completely disconnect power, unplug the power
cord.
NOTE
If your TV does not receive an input signal for several
minutes, it automatically goes into standby mode.
EXIT
Choose your menu Language
English
Español
Français
Select Next Exit
Back Select Next Exit
EXIT
Choose your Picture Mode
Home mode
Retail mode
Home mode default settings are recommended for in-home use.
Retail mode is intended for in-store display and resets video
settings at Power On.
EXIT
Please connect cable or antenna
Channel Installation
Status: Scanning...
ATV Program Installed: 3
DTV Program Installed: 2
Cancel
8%
The first time you turn on your TV, you
must select the TV signal source. Your
TV stores this information, so you do not
need to change the TV signal source
unless it changes. For example, you
change from an outside antenna to cable
TV.
To select the video input source:
1. Turn on your TV, then press [INPUT]
button on the remote or on the TV. The
Input Source menu opens.
2. Press [▲/
▲
] button to highlight the
input source, then press [ENTER]
button.
3. Press [POWER] button again to turn off your TV. When
you turn off your TV, it goes into standby mode.
Selecting the Input Source
INPUT
TV
AV
Component
VGA
HDMI 1
HDMI 2
HDMI 3
HDMI 4
Hi-DMP
EXIT
OK
Select
Enter
Exit

Hisense k560 Specifications

General

Brand	Hisense
Model	k560
Category	LED TV
Language	English