3
Getting Started
Accessories List
Installing the Stand
USER MANUAL
Quick Setup Guide Warranty Card
User Manual Quick Setup Guide Warranty Card Remote Control Battery
×
2 Spacer
×
4
NOTES
1. The LCD display is very fragile, and must be protected at all times when removing the base stand. Be sure that no hard or
sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert pressure
on the front of the TV at any time because the screen could crack.
2. For tabletop use, the TV must be attached to the provided stand as shown on this page.
3. To Wall-Mount, brackets (not provided) must be attached to the TV as shown on next page.
Follow the illustrations below to complete the installation steps:
1. Place your TV on a soft cushioned surface carefully to prevent the screen from scrathing as shown in Figure 1.
2. Align the ridge on the column with the groove in the base plate, then insert the stand column into the base plate, make
sure the FRONT of stand column match the FRONT of base plate. Secure the stand column to the base plate with the five
provided Screws A. See Figure 2.
WARNING
Be sure to disconnect the AC power cord before installing a stand or Wall-Mount brackets.
CAUTION
Use a covered table or bench to lay the TV on and handle the TV carefully to prevent damage to the TV screen or cabinet
during assembly.
Screw A (M5 × L16)
1
ScrewA (M5
×L
16)
×
13 ScrewB (M6
×L
45)
×
4
2
EN-3392 1A
MMTTSS//SSAAPP
DDIISSPP LLAAYY
SSOOUUNN DD
MMUUTTEE
CCCCDD
EEXXIITT
CCOOMMPPOO NNEENNTT
HHDDMM II
RREETTUURRNN
GGUUII DDEE
MM EENNUU
HHii--DDMMPP
VVGGAA
-
IINNPPUU TT
PPIICCTTUURREE
33DD
LLAASSTT
FFAAVV
®
Hii--Smmaarrtt
AASSPPEECCTT
SSLLEEEEPP
EENNTTEERR
soft cloth