4
DP45
1.
ASSEMBLED P.W.B. ADJUSTMENT
1.1 Ser
vice Menu Access
Adjustment Procedure
(1) Press and hold INPUT key on Control Panel and then press POWER key on control panel to access I
2
C
adjustment mode.
(2) Receive signal on main picture. (NTSC, SDTV or HDTV).
Some menu pages have I
2
C adjustments for SDTV and HDTV. The set will automatically allow you to set
these items only when a SDTV or HDTV signal is input to the COMPONENT jacks on the back of the TV. ......
See table below.
(3) Check the OSD according to table on the following pages, using CURSOR G, H on Remote Control.
*: Adjustable Data
Others: Fixed Data (be careful not to change)
(4) Press EXIT key to exit I
2
C ADJUST mode.
NOTES: (1) If the TV I
2
C data is different from the I
2
C Parameter (of the following pages) for fixed data, change
the data.
(2) When exchanging microprocessor or EEPROM and TV is turned on for first time, it requires
initialization of Memory Initial of I
2
C adjustment menu. Press CURSOR E and hold for 3
seconds to initialize memory.
(3) Use FACTORY RESET to set TV to out of factory shipping conditions: Do not use MEMORY
INITIALIZE.
BACK TO ADJUSTMENTS
IMPORTANT: IN CASES AFTER THE SERVICE PERSON PERFORMS A FACTORY RESET OR MEMORY INITIALIZE, YOU
MUST UPLUG TV AND PLUG BACK IN.
To Next Page
Loading...
Need help?
General
