10
English
For how to use, refer to
page 16.
w Dust bag (1 piece)
When cutting the workpiece which has the dimension of “*” there might be some possibility of the lower end of the circular saw to
touch with the workpiece, even if the motor head is located at the lower limit position. Pay attention when cutting the workpiece. For
further details, refer to “PRACTICAL APPLICATIONS” on page 15. Mount the auxilliary board on the fence surface (Refer ( ) the
thickness of auxiliary board). Refer to "6. Cutting large workpieces" on page 18 (Fig. 22)).
ACCESSORIES
WARNING: Accessories for this power tool are mentioned in this Instruction Manual.
The use of any other attachment or accessory can be dangerous and could cause injury or
mechanical damage.
STANDARD ACCESSORIES
Fig. 3
OPTIONAL ACCESSORIES...sold separately
q Extension Holder and Stopper (Fig. 1) (Code No. 320277)
w Vise (A) Assembly (Horizontal Type Code No. 305174)
NOTE: Accessories are subject to change without any obligation on the part of the HITACHI.
APPLICATIONS
Wood and aluminum sash.
q 12" (305mm) TCT Saw
blade (1 piece)
(No. of teeth 60
Code No. 726100I)
For how to use, refer to
page 22.
r Holder (B) (1 piece)
e Vise Assembly w/knob bolt
(1 piece)
For how to use, refer to page
11.
t 10mm × 13 mm Wrench
(1 piece)
y 17 mm Box wrench
(1 piece)
To Next Page
Loading...
Need help?
General
