Hitachi PC-ARH1E User Manual

7 OPTIONAL FUNCTION
1 Press and hold “ ” for “Temp” and “Fan” simultaneously for
at least three seconds during the normal mode (when unit is
not operated).
2 Select the optional mode by pressing “ ” or “ ” for “Temp”
and press “Fan”.
01: Function
Selection
02: Input/Output
Setting
3 Select the indoor unit by pressing “ ” or “ ” for “Temp” and
press “Fan”.
(This screen is NOT displayed when there is only one indoor
unit connected with the controller.
In this case, (4) will be displayed.)
4 Press “ ” or “ ” for “Temp” and select the item.
5 Press “Fan” and change the setting.
6 Press “ ” and “ ” for “Temp” simultaneously to return to the
normal mode.
7.1 OPTIONAL SETTING ITEMS
No. Item Optional function
Individual
Setting
Settings Setting conditions Description
1
b1
Heating temperature
compensation
Models:
RCI-FSN4
RCIM-FSN4E
RCD-FSN3
RPC-FSN3
RPI-FSN5E
RPI-FSN3E(P)E(-f)
RPIM-FSN4E(-DU)
RPK-FSN(H)3M
○
00
Normal (factory setting)
(Setting Temperature + 4 ºC)
This function is used to adjust the
temperature difference between
the temperature read by the
inlet sensor and the real room
temperature.
This is useful when the inlet air
thermistor is not placed inside the
indoor unit or due to uneven heat
load.
Note:
• The “02”, “03”, “04” settings
maynotbeavailabledepending
onthetypeofindoorunit.
• Thissettingshallbeperformed
separately for each indoor
unit,evenincasethatmultiple
indoor units are connected to
oneremotecontroller.
01
No compensation
(Setting Temperature)
02 Setting Temperature + 2 ºC
03 Setting Temperature + 3 ºC
04 Setting Temperature + 1 ºC
Heating temperature
compensation
Models:
RPF(I)-FSN2E
○
00
RPF(I)-FSN2E: Normal
(factory setting)
(Setting Temperature + 2 ºC)
01
No compensation
(Setting Temperature)
02 Setting Temperature + 2 ºC
OPTIONAL FUNCTION
PMML0497 rev.1 - 12/2020
9
ENGLISH

Hitachi PC-ARH1E Specifications

General

Brand	Hitachi
Model	PC-ARH1E
Category	Remote Control
Language	English