Menu Contents
Level 1 Level 2 Level 3 Level 4 Level 5 Level 6
Water Pump Conguration
Outdoor average Timer
Minimum ON Time
Minimum OFF Time
Seizure Protection
Status
Operation Day
Starting Time
Optional Functions
System
Smart Function
Space Functions
Heating Auto On/Off
Auto Heat/Cool
DHW
Circuit pump
Recirculation timer
DHW Boost
Emergency Operation
I/O and Sensors
Inputs
Outputs
Auxiliary sensors
Menu Contents
Level 1 Level 2 Level 3 Level 4 Level 5 Level 6
Controller Settings
Controller Options
Room Names
Date and Time
Adjust Date and Time
European Summer Time
UTC Zone
Screen settings
Language selection
Commissioning
Screed drying
Start Screed Drying
About
System Information
Contact Information
Factory Reset
Return to user mode
Installer mode
Icon means that this menu is available only for installer, a special user with higher access privileges to congure the system. In
order to access the controller as Installer, “OK” and “ ” buttons must be pressed for 3 seconds.
OK +
After that, the “Enter password” message is displayed.
The login password for the Installer is:
Right , Down , Left , Right
Press “OK” to conrm the password.
If the correct access code is entered, the installer mode icon appears on the notications bar (bottom line).
Installer mode icon
After 30 minutes of inactivity, it is necessary to repeat the log in process. To exit the Installer mode and return to the unit menu, hold
down the “ ” button for 3 seconds or go to the “Return to user mode” on the main menu.
? NOTE
The following chapters explain the special settings the Installer can edit. It is important to understand that the Installer can also perform all the actions
available for the typical user.
YUTAKI CASCADE CONTROLLER
PMML0510 rev.1 - 10/2019
116
To Next Page
Loading...
Need help?
General