55
Preparation
Starting & Stopping the Engine
Basic Operation & Riding
Always follow the proper starting
procedure described below.
For your safety, avoid starting or operating
the engine in an enclosed area such as a
garage. Your scooter’s exhaust contains
poisonous carbon monoxide gas which can
collectrapidlyinanenclosedareaand
cause illness or death.
Your scooter is equipped with a side stand
ignition cut-off system. If the side stand is
down––the engine cannot be started.
Do not use the electric starter for more
than 5 seconds at a time. Release the start
button for approximately 10 seconds
before pressing it again.
Operate the start button for slightly longer
than usual without opening the throttle if
the scooter has been left standing for a
long time or when the fuel tank has just
been refilled.
Before starting, insert the key, turn the
ignition switch ON, and confirm the
following:
The engine stop switch is set to RUN.
The low oil pressure indicator is ON.
The PGM-FI malfunction indicator
lamp (MIL) is OFF.
The high coolant temperature indicator
is OFF.
The V-matic indicator is OFF.
The ABS indicator light is ON.
(FSC600A)
０９／１２／１４ １４：５０：０９ ３１ＭＧＦ６１０ ００６４
To Next Page
Loading...
Need help?
General