CONTROLS & FEATURES
30
Overload Alarm (Indicator)
If the generator is overloaded (in excess of 2.2 kVA), or if there is a short circuit in
a connected appliance, the overload alarm indicator (red) will come ON. The
overload alarm indicator (red) will stay ON, and after about four seconds,
current to the connected appliance(s) will shut off, and the output indicator
(green) will go OFF. However, the engine will continue to run.
If the overload alarm indicator (red) blink continuously, it suggests an abnormal
of inverter unit (see page 73).
Oil Alert®/Check Indicator
The Oil Alert®
system is designed to prevent engine damage caused by an
insufficient amount of oil in the crankcase. Before the oil level in the crankcase
can fall below a safe limit, the Oil Alert/Check indicator (red) comes ON and the
Oil Alert system automatically will stop the engine (the engine switch will
remain in the ON position).
If the engine stops or the Oil Alert/Check indicator (red) comes ON when you
pull the starter grip, check the engine oil level (see page 35) before
troubleshooting in other areas.
The Oil Alert/Check Indicator also comes ON when the engine is automatically
stopped by the CO-MINDER.
OVERLOAD ALARM INDICATOR
(RED)
OIL ALERT/CHECK INDICATOR
(RED)
To Next Page
Loading...
Need help?
General
