OPERATION
49
3. Plug an appliance into a receptacle.
When EU2200i is connected with EU2200i:
Plug in the appliance following the instruction provided with the parallel
operation cable kit.
When EU2200i is connected with EU2200i Companion:
Plug an appliance into the 30 A twist lock receptacle.
4. Turn on the appliance.
If the generators are overloaded (see page 52), or if there is a short circuit in a
connected appliance, the overload alarm indicator (red) will go ON. The
overload alarm indicator (red) will stay ON, and after about four seconds, current
to the connected appliance(s) will shut off, and the output indicator (green) will
go OFF. Stop both engines and investigate the problem.
Determine if the cause is a short circuit in a connected appliance or an overload.
Correct the problem and restart the generator.
30 A twist lock receptacle
L5-30P PLUG
To Next Page
Loading...
Need help?
General
