12
Hot Restart
If the engine is operated at higher ambient temperatures, then turned off
and allowed to sit for a short time, it may not restart on the first pull.
If necessary, use the following procedure:
IMPORTANT SAFETY PRECAUTION
Turn the engine switch to the OFF position before performing the
following procedure. This will prevent the engine from starting and
running at maximum speed when the throttle trigger is in the FAST
speed position. If the engine starts with the throttle trigger in the FAST
speed position, the equipment can move forward rapidly or the
attachment can spin at maximum speed.
1. Turn the engine switch to the OFF position.
2. Move the choke lever to the OPEN position.
3. Hold the throttle trigger in the FAST speed position.
4. Pull the starter grip 3 to 5 times.
Follow the STARTING THE ENGINE procedure on page 11 and start the
engine with the choke lever in the OPEN position.
SETTING ENGINE SPEED
Squeeze the throttle trigger for the desired engine speed.
STOPPING THE ENGINE
1. Release the throttle trigger.
2. Move the engine switch to the OFF position.
THROTTLE TRIGGER INTERLOCK
THROTTLE TRIGGER
FAST
SLOW
ENGINE SWITCH
OFF
OFF
THROTTLE TRIGGER
SERVICING YOUR POWERHEAD
THE IMPORTANCE OF MAINTENANCE
Good maintenance is essential for safe, economical and trouble-free
operation. It will also help reduce pollution.
To help you properly care for your powerhead, the following pages
include a maintenance schedule, routine inspection procedures, and
simple maintenance procedures using basic hand tools. Other service
tasks that are more difficult, or require special tools, are best handled by
professionals and are normally performed by a Honda technician or other
qualified mechanic.
The maintenance schedule applies to normal operating conditions.
If you operate your powerhead under severe conditions, such as
sustained high-load or high-temperature operation, or use in unusually
wet or dusty conditions, consult your Honda servicing dealer for
recommendations applicable to your individual needs and use.
Maintenance, replacement, or repair of the emission control devices
and systems may be performed by any powerhead repair
establishment or individual, using parts that are ‘‘certified’’ to EPA
standards.
MAINTENANCE SAFETY
Some of the most important safety precautions follow. However, we
cannot warn you of every conceivable hazard that can arise in
performing maintenance. Only you can decide whether or not you
should perform a given task.
Failure to properly maintain this powerhead, or failing to
correct a problem before operation, could result in a
significant malfunction.
Some malfunctions can cause serious injuries or death.
Always follow the inspection and maintenance
recommendations and schedules in this owner's manual.
Improper maintenance can cause an unsafe condition.
Failure to properly follow maintenance instructions and
precautions can cause serious injuries or death.
Always follow the procedures and precautions in this
owner’s manual.
31VP86080.fm 12 ページ ２０２３年１０月５日 木曜日 午後２時２２分
To Next Page
Loading...
Need help?
General
