EasyManuals Logo

Honda umc435 User Manual

Honda umc435
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14
REFUELING
Recommended Fuel
This engine is certified to operate on unleaded gasoline with a pump
octane rating of 86 or higher.
Refuel in a well ventilated area with the engine stopped. If the engine has
been running, allow it to cool first. Never refuel the engine inside a
building where gasoline fumes may reach flames or sparks.
You may use unleaded gasoline containing no more than 10% ethanol
(E10) or 5% methanol by volume. In addition, methanol must contain
cosolvents and corrosion inhibitors. Use of fuels with content of ethanol
or methanol greater than shown above may cause starting and/or
performance problems. It may also damage metal, rubber, and plastic
parts of the fuel system. Engine damage or performance problems that
result from using a fuel with percentages of ethanol or methanol greater
than shown above are not covered under the Warranty.
If your equipment will be used on an infrequent or intermittent basis,
please refer to the ‘‘Fuel’’ section of the ‘‘STORING YOUR POWERHEAD’’
chapter (see page 20) for additional information regarding fuel
deterioration.
Never use gasoline that is stale, contaminated, or mixed with oil. Avoid
getting dirt or water in the fuel tank.
Fuel can damage paint and some types of plastic. Be careful not to spill fuel
when filling your fuel tank. Damage caused by spilled fuel is not covered
under the Distributor's Limited Warranty (U.S.) / Distributor's Warranty (CA.).
1. Check the fuel level by looking through the translucent fuel tank.
2. If the fuel level is low, refuel in a well-ventilated area with the engine
stopped. If the engine has been running, allow it to cool.
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling fuel.
Stop the engine and let it cool before handling fuel.
Keep heat, sparks, and flame away.
Handle fuel only outdoors.
Keep away from your vehicle.
Wipe up spills immediately.
FUEL TANK CAP
FUEL TANK
UPPER FUEL
LIMIT LEVEL
To refuel, rest the engine a level surface with the fuel tank cap facing up,
as shown. Remove the fuel tank cap, and fill the tank with gasoline to the
bottom of the filler neck. Refuel carefully to avoid spilling fuel. Do not
overfill. There should be no fuel in the filler neck. After refueling, tighten
the fuel tank cap securely.
Keep gasoline away from appliance pilot lights, barbecues, electric
appliances, power tools, etc.
Spilled fuel is not only a fire hazard, it causes environmental damage.
Wipe up spills immediately.
ENGINE OIL
Oil is a major factor affecting performance and service life.
Use 4-stroke automotive detergent oil.
Recommended Oil
Use 4-stroke motor oil that meets or exceeds the requirements for API
service classification SJ or later (or equivalent). Always check the API
service label on the oil container to be sure it includes the letters SJ or
later (or equivalent).
SAE 10W-30 is recommended for general use. Other viscosities shown in
the chart may be used when the average temperature in your area is
within the indicated range.
Oil Level Check
Check the engine oil level before each use, or every 10 hours if operated
continuously.
Check the engine oil level with the engine stopped and in a level
position.
1. Remove the engine oil filler cap and wipe it clean.
2. Check the oil level. If it is below the oil filler opening, fill with the
recommended oil to the oil filler opening. Do not overfill.
AMBIENT TEMPERATURE
31VP86080.fm 14 ペー 2023年10月5日 木曜日 午後2時22

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honda umc435 and is the answer not in the manual?

Honda umc435 Specifications

General IconGeneral
BrandHonda
Modelumc435
CategoryTrimmer
LanguageEnglish

Related product manuals