Honda Wave 110i User Manual

Engine Oil u Changing Engine Oil
64
Maintenance
3. Turn the ignition switch off, stop the
engine and wait for 2 to 3 minutes.
4. Place a drain pan under the drain bolt.
5. Remove the oil fill cap/dipstick, drain
bolt, and sealing washer to drain the oil.
u Discard the oil at an approved
recycling centre.
6. Install a new sealing washer onto the
drain bolt.
7. Install the drain bolt and tighten.
8. Fill the crankcase with the recommended
oil (
2 P. 44) and install the oil fill cap/
dipstick.
9. Check the oil level. 2 P. 62
10. Check that there are no oil leaks.
Drain bolt
Sealing washer
Torque: 24 N·m (2.4 kgf·m, 18 lbf·ft)
Required oil
When changing oil:
0.8 litres (0.8 US qt, 0.7 Imp qt)
12 AFS110-32KWWH00.book 64 ページ ２０１１年１０月２６日 水曜日 午後５時２２分
http://www.motorcycle.in.th

Honda Wave 110i Specifications

General

Displacement	109.5 cc
Bore x Stroke	50.0 mm x 55.6 mm
Compression Ratio	9.0:1
Fuel System	PGM-FI (Programmed Fuel Injection)
Transmission	4-speed
Starter	Electric and kick
Final Drive	Chain
Front Suspension	Telescopic fork
Rear Brake	Drum
Front Tire	70/90-17M/C 38P
Rear Tire	80/90-17M/C 50P
Ground Clearance	135 mm
Engine Type	4-stroke
Rear Suspension	Twin shock
Front Brake	Disc
Ignition System	Full Transistorized