Honda Wave 110i User Manual

81
continued
Troubleshooting
Tyre Puncture
Repairing a puncture or removing a wheel
requires special tools and technical expertise.
We recommend you have this type of service
performed by your dealer.
After an emergency repair, always have the
tyre inspected/replaced by your dealer.
Tube Repair and Replacement
If a tube is punctured or damaged, you
should replace it as soon as possible. A tube
that is repaired may not have the same
reliability as a new one, and it may fail while
you are riding.
If you need to make a temporary repair by
patching a tube or using an aerosol sealant,
ride cautiously at reduced speed and have
the tube replaced before you ride again.
Anytime a tube is replaced, the tyre should
be carefully inspected as described.
Removing Wheels
Follow these procedures if you need to
remove a wheel in order to repair a puncture.
3 WARNING
Riding your motorcycle with a
temporary tyre or tube repair can be
risky. If the temporary repair fails, you
can crash and be seriously injured or
killed.
If you must ride with a temporary tyre
or tube repair, ride slowly and
carefully and do not exceed 50 km/h
(30 mph) until the tyre and tube is
replaced.
12 AFS110-32KWWH00.book 81 ページ ２０１１年１０月２６日 水曜日 午後５時２２分
http://www.motorcycle.in.th

Honda Wave 110i Specifications

General

Displacement	109.5 cc
Bore x Stroke	50.0 mm x 55.6 mm
Compression Ratio	9.0:1
Fuel System	PGM-FI (Programmed Fuel Injection)
Transmission	4-speed
Starter	Electric and kick
Final Drive	Chain
Front Suspension	Telescopic fork
Rear Brake	Drum
Front Tire	70/90-17M/C 38P
Rear Tire	80/90-17M/C 50P
Ground Clearance	135 mm
Engine Type	4-stroke
Rear Suspension	Twin shock
Front Brake	Disc
Ignition System	Full Transistorized