Honeywell SRX3 User Manual

3. Slide the hard hat onto your head, pulling the earcup out as needed, then
position the hat so the earpad is snug against your ear.
4. If the earpad sits too low or high on your ear, take off the hard hat and
adjust the earcup by pulling or pushing the arms of the fork out of or into
the fork sleeves.
5. Insert the SRX2/SRX3 electronics module into the pocket on the earcup by
aligning the notches on the speaker and earcup pocket.
6. Push the electronics module into the earcup pocket until it is firmly seated.
Storing the SRX2/SRX3 Hard-Hat Headset
Honeywell recommends storing the hard hat with the headset earcup moved up on the
side of the hat (see figure below) to reduce the risk of damage.
1. Remove the electronics module from the headset. The electronics module
can be used by another worker or stored separately.
2. Detach the microphone cap from the electronics module, and dock it in the
mic cap pocket located above the headset earcup.
31 SRX3 User Guide - Preliminary

Honeywell SRX3 Specifications

General

Brand	Honeywell
Model	SRX3
Category	Headsets
Language	English