Honeywell SRX3 User Manual

headsets
at your
site:
(headband) with the symbol to center
of the raised oval on the side of the device
with the symbol, until the device state
(ring) indicator blinks green. This
associates the operator's headband to the
device enabling VoiceConsole to
recognize the operator.
2. Touch the side of the A700/A700x device
that has the symbol and the oval area
of the headset's keypad section together,
aligning the ovals on each and holding
them together steadily, until the device
state (ring) indicator blinks green. Note
that there is a 30-second timeout after a
headband is recognized in step one. You
must pair the electronics module within
30 seconds from associating the
headband for full functionality.
NOTE
If the device state indicator blinks red, the NFC read was not successful,
and you should attempt to perform the read again .
If you are
not
sharing
headsets
at your
site:
You only need to pair the device to the headset electronics module:
1. Touch the side of the A700/A700x device
that has the symbol and the oval area
of the headset's keypad section together,
aligning the ovals on each and holding
them together steadily, until the device
state (ring) indicator blinks green.
NOTE
If the device state indicator blinks red, the NFC read was not successful,
and you should attempt to perform the read again.
Using TouchConnect to Obtain
Operator Information from the
Headband
Using TouchConnect to Pair an
SRX2 or SRX3 with an A700 or
A700x Device
SRX3 User Guide - Preliminary 40

Honeywell SRX3 Specifications

General

Brand	Honeywell
Model	SRX3
Category	Headsets
Language	English