WEB-700 WEB-700-O CP-700
95-7776—01 2
WEB-700; WEB-700-O; CP-700
ABOUT THIS GUIDE
This document covers the mounting and wiring of the Tridium®
WEB/CP-700 (T-700) controller. It assumes that you are an
engineer, technician, or service person who is performing control system installation. Instructions in this document apply to the
following products:
NOTE: Not covered in this document is the Niagara
AX
software installation and configuration required for a fully functioning unit.
Refer to the Niagara AX Install and Startup Guide for this information.
In addition, the mounting and wiring of controller expansion options are covered in separate documents. See the section
About Expansion Options, page 12.
Related Documentation
For more information on configuring and using the WEB/CP-700 controller, consult the following documents:
• IO-16-REM-H Installation and Configuration Instructions, Form # 95-7768
• NPB-LON Option Installation Sheet, Form # 62-0263
• NPB-MDM Option Installation Sheet, Form # 95-7730
• NPB-GPRS-W-H Installation Sheet, Form # 62-0301
• Niagara AX Install and Startup Guide
• NiagaraAX Nrio Guide
• NiagaraAX User Guide
Model Description
WEB-700
WEB-700-O
CP-700
DIN mount 7 series controller, powered by separate plug-in power supply module or wall mount
AC power adapter. Controller supports optional remote I/O expansion modules and internal
communications option cards.
NPB-PWR-UN-H 90–263Vac universal input/15Vdc output power supply module, DIN mountable.
NPB-WPM-US Wall-mount, 120V AC power adapter.
To Next Page
Loading...
Need help?
General
