WEB-700 WEB-700-O CP-700
7 95-7776—01
WEB-700; WEB-700-O; CP-700
WARNING
A 120Vac or 240Vac circuit powers the NPB-PWR-UN-H power supply for the controller.
Disconnect power before installation or servicing to prevent electrical shock or equipment damage.
Make all connections in accordance with national and local electrical codes. Use copper conductors only.
To reduce the risk of fire or electrical shock, install in a controlled environment relatively free of contaminants.
This device is only intended for use as a monitoring and control device. To prevent data loss or equipment
damage, do not use it for any other purpose.
Static Discharge Precautions
Static charges produce voltages high enough to damage electronic components. The microprocessors and associated circuitry
within a WEB/CP-700 controller are sensitive to static discharge. Follow these precautions when installing, servicing, or operating
the system:
CAUTION
Work in a static-free area.
Discharge any static electricity you may have accumulated. Discharge static electricity by touching a known,
securely grounded object. Do not handle printed circuit boards (PCBs) without proper protection against static
discharge. Use a wrist strap when handling PCBs. The wrist strap clamp must be secured to earth ground.
Battery Precautions
CAUTION
The NiMH battery used in this device may present a risk of fire or chemical burn if mistreated. Do not
disassemble, heat above 122ºF (50ºC), or incinerate. Replace battery pack with NPB-BATT-7 only. Use of another
battery may present a risk of fire or explosion.
Dispose of used battery promptly. Keep away from children. Do not disassemble and do not dispose of in fire.
Replace external backup battery with Listed Power Source Battery Only.
MOUNTING
NOTE: This product is intended for indoor use only. The unit should not be exposed to ambient conditions outside of the range
of 32ºF (0ºC) to 122ºF (50ºC), or relative humidity outside the range of 10 to 90% at 77ºF (25ºC), non-condensing. Refer
to Environment, page 5 for further details on mechanical and storage specifications.
Before mounting the unit, install any option card(s) and memory upgrade. See About Expansion Options, page 12.
Mount the controller in a location that allows clearance for wiring, servicing, and module removal. Additional mounting information
applies, as follows:
To Next Page
Loading...
Need help?
General
