11
Place your foot on the floorhead. Pull the
handle backwards to recline.
To remove the battery press both the
buttons to release.
Slide the battery into the machine until it
clicks into place.
WARNING: The brushbar in the floorhead constantly rotates when activated. Never use the floorhead on one spot
for an extended period of time as the brushbar may damage the surface. To prevent any damage being sustained,
test on an inconspicuous area of the flooring/surface first.
CAUTION: Always take extra care when using the vacuum on the stairs.
OPERATION
• ON/OFF power button.
• Unit turns on in Default mode.
• To increase runtime for hard
oors and everyday messes.
• To increase suction for more
embedded messes.
• Battery LED is illuminated WHITE
when on and RED when battery
is low.
NOTE: Pressing the - or + will increase
or decrease the power level from where
it is currently running.
CAUTION: Store the vacuum
safely after use to prevent tripping
accidents.
CAUTION: Not to be used for
grooming a pet.
NOTE: When less than 20% charge
is remaining the low battery
indicator will flash red indicating the
battery is running low and charging
is required.
CAUTION: If the brushbar in the
floorhead has been obstructed, the
brushbar motor protection sensor
may activate. The brushbar will
stop and the machine may switch
off. To reset, switch the machine
off and remove the battery. Remove
the floorhead from the reach wand/
handheld and clear any obstruction.
Wait 1 minute before refitting the
floorhead. Install the battery and
switch the machine on.
During use, press the battery symbol on
the battery. The lights will illuminate
indicating how much charge is
remaining.
GETTING STARTED
To Next Page
Loading...
Need help?
General
