SAFETY GUIDE
19
Pull the brushbar out from the brushbar
housing.
Using a coin, turn the brushbar lock
anticlockwise to release the brushbar.
To remove any threads or hair slide
the blade of a pair of scissors into the
groove on the brushbar and cut along
the groove. Clear any dirt/debris inside
the housing of the tool.
NOTE: If the brushbar in the motorised pet tool has been obstructed, the brushbar motor protection sensor may
activate. The brushbar will stop and the machine may switch off. To reset, switch the machine off and remove the
battery. Remove the tool and clear any obstruction. Wait 1 minute before refitting the tool. Install the battery and
switch the machine on.
Check the inlet for any blockages
and use a blunt object to remove the
blockage.
Refit the brushbar and turn the
brushbar lock clockwise to lock.
REMOVING AND CLEANING THE MOTORISED PET TOOL BRUSHBAR
(MODEL F18OPSV22J2)
WARNING: To reduce the risk of personal injury, always turn power switch off and remove battery before cleaning
or servicing.
CLEANING AND MAINTENANCE
To Next Page
Loading...
Need help?
General
