IMPORTANT
Be sure to replace the Quick Spout Pour Cap to ensure proper suction.
IMPORTANT
Regarding Dirty Water Tank Lid: For full suction it is important that the Dirty Water Tank Lid is securely in place. If
misplaced, poor to no suction will result.
IMPORTANT
For full suction, it is important that the Dirty Water Tank is properly secured before cleaning.
Continue using dry strokes until little water is visible passing through the nozzle.
For best results, Hoover recommends rinsing carpet with water only. This removes residual carpet cleaning
solution. Fill Solution Tank with water and repeat. For heavily soiled areas, repeat. Avoid saturating carpet.
NOTE: Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in
suction (see “Automatic shut-off”). You will also see the float rise and shut off suction at the same
time.
NOTE: It is best to alternate wet and dry strokes as described above. See cleaning modes section to
choose best cleaning mode for desired results.
CAUTION
Do not clean over floor electrical outlets. Water will drip from the brushes and underside of the product after use
and may puddle. To avoid damage to wood and laminate flooring and to avoid potential slip hazard, after use (a)
do not leave the product on wood and laminate surfaces and move to a hard surface and (b) place unit on an
absorbent material (such as a towel) to soak up drips.
Using your Power Scrub Elite™
1. Choose cleaning mode by turning the dial on the base to “Quick Clean” or “Deep Clean” mode.
NOTE: See cleaning mode descriptions.
2. Ensure Wash/Rinse dial on the Clean Water Tank is turned to “Wash”.
To Next Page
Loading...
Need help?
General
