Operating Steam Cleaner
1. Attach the desired accessory, following the instructions in
the section “Attaching the Accessory Adaptors.”
2. Plug in the steam cleaner to a grounded outlet.
3. Press the power button (D).
4. The blue power indicator light should stay
illuminated. If the light does not illuminate, check
the “Troubleshooting” section for more details.
5. Keep canister level during use.
6. The steam cleaner should take between 6-8
minutes to heat up to steam temperatures, which
will be indicated when the green “steam ready
light” illuminates.
WARNING! When pressing the steam trigger for the first time or after a
certain amount of time out of use, water may form due to the initial heat
instability. This is normal and is simply caused by steam condensation in
the hose. If this occurs, it is advisable to release the steam into a cloth or
sink, keeping steam trigger pressed and then wait a few seconds until the
droplets disappear.
IMPORTANT! To prevent steam condensation in the hose, turn the steam
control knob counter - clockwise all the way when you are not using steam
cleaner. This will shut off steam flow to the hose.
To Next Page
Loading...
Need help?
General
