Using on Carpet
WARNING! Do not clean over floor electrical outlets. Do not use steam cleaner or
press the steam trigger without water in the water tank.
IMPORTANT! When using on carpets, always ensure the multi-surface microfibre
pad is properly attached to the mop head.
1. Attach multi-surface microfibre pad to mop head.
2. The steam cleaner should take between 6-8 minutes to heat up to steam temperatures,
which will be indicated when the green “steam ready” light illuminates.
3. Place the mop head (with microfibre pad attached) into the carpet glider.
4. To recline the steam cleaner place foot on mop head and gently pull handle backwards.
5. To produce steam squeeze the steam trigger.
6. Move the steam mop slowly backwards and forwards across the floor paying
particular attention to high traffic areas.
NOTE: The carpet glider does not stay attached to the mop head, it is designed in
this way.
To Next Page
Loading...
Need help?
General
