To Next Page

To Previous Page

Preparing the rack for component installation 16

• Position and install the baying option kit before populating the racks with components.

• The weight of the rack should rest on the leveling feet.

Rack stabilizer option kit

The HP Rack Stabilizer Option Kit provides stability and support and prevents possible tipping when

equipment is installed, removed, or accessed within the rack.

There are four stabilizer kit options:

• Standard 600-mm (23.6-in) or 800-mm (31.5-in) front foot—Required if you have a stand-alone

rack.

NOTE: The standard 600-mm (23.6-in) front foot ships with all HP 10622 G2 Racks.

Questions and Answers:

Need help?

Do you have a question about the HP 10842 G2 and is the answer not in the manual?

HP 10842 G2 Specifications

General