Reverse this procedure to reassemble and install the display assembly components.
Bottom cover
Description Spare part number
Models without eMMC modules:
Bottom cover for use in black models 929709-001
Bottom cover for use in white models 931244-001
Bottom cover for use in blue models L00440-001
Models with eMMC modules:
Bottom cover for use in black models 940558-001
Bottom cover for use in white models 940559-001
Bottom cover for use in blue models L00746-001
Rubber Kit for use in black models 929645-001
Rubber Kit for use in white models 931245-001
Rubber Kit for use in blue models L00441-001
Before removing the bottom cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see Battery on page 34).
To remove the bottom cover:
1. Position the computer upside down with the front toward you.
2. Remove the upper rubber foot (1) so you can access the screws underneath.
3. Remove the three Phillips PM2.5×6.0 screws (2) that were under the upper rubber foot.
32 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
Need help?
General
