14 HP Software Solutions Summary ENWW
Internet Printer Connection
Software
HP Jetdirect print servers (firmware version x.07.16 or later)
support the Internet Printing Protocol (IPP). Using the appropriate
software on your system, you can create an IPP print path from your
system to any HP
Jetdirect-connected printer over the Internet.
Note For incoming print path requests, the network
administrator must configure the firewall to accept
incoming IPP requests. Security features available
in the software are currently limited.
Windows 2000/XP/Server 2003
Note Contact Microsoft for support of Windows IPP
software.
For supported Windows systems, Internet printing connection
software is included with the system.
To set up a print path from a Windows 2000 system to an HP
Jetdirect-connected Internet printer, proceed as follows:
1. Open the Printers folder (click Start, select Settings, and select
Printers).
2. Run the Add Printer wizard (double-click Add Printer), then
click Next.
3. Select Network Printer and click Next.
4. Select Connect to a printer on the Internet and enter the
print server’s URL:
http://IP_address/ipp/[port#]
where IP_address is the IP address configured on the HP
Jetdirect print server, and [port#] is an optional parameter that
identifies the port number on the multi-port HP Jetdirect
external print server (port1, port2, or port3) that the printer is
connected to. The default is port1.
To Next Page
Loading...
Need help?
General
