52 Configuring for LPD Printing ENWW
10. Choose whether this printer will be available to other
computers. If shared, enter a share name that identifies the
printer to other users. Click Next.
11. If desired, enter a location and other information for this printer.
Click Next.
12. Choose whether to print a test page, and click Next.
13. Click Finish to close the wizard.
Verifying the Configuration
Print a file from any application. If the file prints correctly, the
configuration was successful.
If the print job is not successful, try printing directly from DOS
using the following syntax:
lpr -S<ipaddress> -P<queuename> filename
where ipaddress is the IP address of the print server, queuename
is the name “raw” or “text” and filename is the file you wish to
print.If the file prints correctly, the configuration was successful. If
the file does not print, or prints incorrectly, see the chapter
“
Troubleshooting the HP Jetdirect Print Server.”
Printing from Windows Clients
If the LPD printer on the Windows server is shared, Windows
clients can connect to the printer on the server using the Windows
Add Printer utility in the Printers folder.
To Next Page
Loading...
Need help?
General
