HP 300X - JetDirect Print Server User Manual

40 TCP/IP Configuration ENWW
Moving to Another Network
When moving an HP Jetdirect print server that is configured with
an IP address to a new network, make sure that the IP address does
not conflict with addresses on the new network. You may change
the IP address of the print server to one that can be used on the new
network, or erase the current IP address and configure another
address after you are installed on the new network. Cold reset the
print server (see Chapter
6, “Troubleshooting the HP Jetdirect
Print Server,” for instructions).
If the current BOOTP server is not reachable, you may need to
locate a different BOOTP server and configure the printer to this
server.
If the print server was configured using BOOTP, DHCP or RARP,
edit the appropriate system files with updated settings. If the IP
address was manually set (for example, Telnet), reconfigure IP
parameters as described in this chapter.

HP 300X - JetDirect Print Server Specifications

General

Brand	HP
Model	300X - JetDirect Print Server
Category	Print Server
Language	English