HP Compaq 14 User Manual

Heat sink assembly
NOTE: The heat sink assembly spare part kit includes replacement thermal materials.
Description Spare part number
Heat sink for use in models with Intel processors and discrete graphics 757602-001
Heat sink for use in models with Intel processors and UMA graphics 757603-001
Heat sink for use in models with Intel Pentium and Celeron processors and UMA graphics 766504-001
Heat sink for use in models with an Intel Core i3-3217U processor and UMA graphics 766503-001
Heat sink for use in models with an Intel Core i3-3217U processor and discrete graphics 766502-001
Heat sink for use in models with AMD processors and discrete graphics 766567-001
Heat sink for use in models with AMD processors and UMA graphics 766568-001
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3.0 in) of clearance on the left side of the
computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature sensor
and is designed to turn on automatically when high temperature conditions exist. These conditions are
affected by high external temperatures, system power consumption, power management/battery
conservation configurations, battery fast charging, and software requirements. Exhaust air is displaced
through the ventilation grill located on the left side of the computer.
Before removing the heat sink assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 49), and then remove the following components:
●
Service cover (see
Service cover on page 55)
●
Keyboard (see
Keyboard on page 57)
●
Top cover (see
Top cover on page 60)
●
WLAN module (see
WLAN module on page 71)
●
USB board (see
USB board on page 67
●
Hard drive (see
Hard drive on page 68
●
System board (see
System board on page 83)
To remove the heat sink assembly:
1. Position the system board upside down.
2. Remove the PM2.0×3.0 screws (1) that secure the heat sink assembly to the system board.
Component replacement procedures 91

HP Compaq 14 Specifications

General

Brand	HP
Model	Compaq 14
Category	Laptop
Language	English