Service Reference Guide, d200 336493-004 6–9
Removal and Replacement Procedures— Microtower Type 2 Chassis
6.7 Drives
The computer supports up to five drives that may be installed in various configurations.
This section describes the procedure for replacing or upgrading the storage drives. A Torx T-15
screwdriver is needed to remove and install the guide screws on a drive.
Ä
CAUTION: Make sure personal files on the hard drive are backed up to an external storage device
before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard
drive, you will need to run the Restore Plus! CD to load the HP factory-installed files.
6.7.1 Drive Positions
✎
Some models may not have an air shroud surrounding the processor.
Drive Positions
Item Description Item Description
1 Optical drive 4 Hard drive
2 Optical drive 5 Hard drive
3 Diskette drive
*An optical drive is a CD-ROM, CD-R/RW, DVD-ROM, DVD-R/RW, or CD-RW/DVD Combo
drive.
To Next Page
Loading...
Need help?
General