Hardware Setup
Step 4: Connect the Tablet PC to
External Power
To connect the tablet PC to external AC power:
ā
Power cords and electrical outlets vary in appearance by region
and country.
1. Plug the AC adapter into the power connector 1.
2. Plug the power cord into the AC adapter 2, and then into
an AC outlet 3.
When the tablet PC receives AC power, the battery pack begins
to charge and the battery light 4 (on the front of the tablet PC)
is turned on. When the battery pack is fully charged, the battery
light is turned off.
It is recommended that you leave the tablet PC connected
to external power until the battery pack is fully charged and the
battery light is turned off. (A partially charged new battery pack
can run the tablet PC after software setup is complete, but battery
charge displays will not be accurate until the new battery pack has
been fully charged.)
Getting Started 1ā7
To Next Page
Loading...
Need help?
General
