Removal and replacement procedures 30
7.
Loosen the screw securing the power block to the chassis, press down on the release lever, and then
slowly pull the power block out 2.54 to 5.08 cm (1 to 2 in). Do not remove the power block any further
because the cable management arm is still attached.
8. Disengage the cable management arm lock from each hard drive drawer:
a. Pull the mechanism up and then toward the rear of the chassis to disengage it from the locking plate.
b. Slide the cable management arm off both locking plates.
To Next Page
Loading...
Need help?
General