To Next Page

To Previous Page

Power connector cable

Description Spare part number

Power connector cable 807522-001

Before removing the power connector cable, follow these steps:

1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect the power from the computer by unplugging the power cord from the computer.

3. Disconnect all external devices from the computer.

4. Remove the top cover (see Top cover on page 27).

5. Remove the system board (see System board on page 39).

6. Remove the display (see Display assembly subcomponents on page 19).

Remove the power connector cable:

1. Remove the Phillips PM2.0×2.0 screw (1) that secures the bracket to the computer.

2. Remove the bracket from the computer (2).

3. Pull the connector out from under the rear corner of the computer (3).

4. Remove the power connector cable.

Reverse this procedure to install the power connector cable.

58 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts

Questions and Answers:

Need help?

Do you have a question about the HP ENVY x360 Convertible and is the answer not in the manual?

HP ENVY x360 Convertible Specifications

General

Series	ENVY x360
Convertible	Yes
Touchscreen	Yes
Display Size	13.3 inch / 15.6 inch
RAM	8GB or 16GB
Storage	512 GB SSD / 1 TB SSD
Graphics	AMD Radeon Graphics or Intel Iris Xe Graphics
Battery	3-cell Li-ion
Weight	1.32 kg
Ports	1x headphone/microphone combo
Wireless	Wi-Fi 6
Audio	Audio by Bang & Olufsen; Dual speakers
Processor Type	Intel Core i7 / AMD Ryzen 7