Booting in Continuous Loop
Booting in Continuous
Loop
Yes
Done
Reboot the thin client
No
No
Service the unit.
Note: Refer to the
Warranty for coverage
information.
Reimage the system.
Yes
Boot
OK?
Boot
OK?
Boot
OK?
Using t5000 F10 Setup, change boot
priority to factory defaults.
1. USB Device
2. Flash*
3. Network
*Check "Amount of Flash memory" in
system information table.
Reboot the thin client
If you are using XPe OS, disable the
write filter. Chek that Altiris 5.6
Deployment server is being used.
Reboot the thin client
Yes
Yes
No
t5000 Troubleshooting Flow Chart
End
46 Chapter 4 Diagnostics and Troubleshooting
To Next Page
Loading...
Need help?
General