1
Preparing for installation
The HPE MSR954 Router Series includes the models in Table 1.
Table 1 HPE MSR954 Router Series models
Product code HPE description RMN
JH296A HPE MSR95X 1GbE+SFP Router BJNGA-BB0036
JH297A HPE MSR95X-W 1GbE+SFP (WW) Router BJNGA-BB0037
JH298A HPE MSR95X-W 1GbE+SFP LTE (AM) Router BJNGA-BB0038
JH299A HPE MSR95X-W 1GbE+SFP LTE (WW) Router BJNGA-BB0039
JH373A HPE MSR954 1GbE Dual 4G (WW) Router BJNGA-BB0042
IMPORTANT:
For regulatory identification purposes, every MSR954 router is assigned a regulatory model
number (RMN). These regulatory model numbers should not be confused with the marketing
name HPE MSR954 or the product codes.
Safety recommendations
To avoid any equipment damage or bodily injury, read the following safety recommendations before
installation. Note that the recommendations do not cover every possible hazardous condition.
Safety symbols
When reading this document, note the following symbols:
WARNING means an alert that calls attention to important information that if not understood or
followed can result in personal injury.
CAUTION means an alert that calls attention to important information that if not understood or
followed can result in data loss, data corruption, or damage to hardware or software.
General safety recommendations
• Keep the router and installation tools away from walk areas.
• Place the router in a dry and flat location and make sure anti-slip measures are in place.
• Remove all external interface cables and power cords before moving the router.
Electricity safety
• Locate the external power switch in the room before installation. Shut off the power
immediately if an accident occurs.
• Make sure the router is reliably grounded.
• Do not remove and install the chassis cover when the router is operating.
• Connect the interface cables correctly.
• Use an uninterrupted power supply (UPS).
To Next Page
Loading...
Need help?
General
