HP FlexNetwork MSR 954 Installation Guide

5
Product code Description Quantity Applicable models
5184-7298
Rubber feet
1 kit
• JH296A
• JH297A
• JH298A
• JH299A
• JH373A
5190-1728
Bail latch
1 kit
• JH296A
• JH297A
• JH298A
• JH299A
5190-1727
Console cable
1 kit
• JH296A
• JH297A
• JH298A
• JH299A
• JH373A
Figure 1 User-supplied tools and equipment
Pre-installation checklist
Item Requirements
Installation
site
Ventilation
• There is a minimum clearance of 10 cm (3.9 in) around the air
inlet and outlet vents.
• An adequate ventilation system is available at the installation site.
Temperature 0°C to 40°C (32°F to 104°F)
Relative humidity 5% to 90% (noncondensing)
Cleanness
Dust concentration ≤ 3 × 10
4
particles/m
3
(no visible dust on the
tabletop over three days)
ESD prevention
• The router and floor are reliably grounded.
• The equipment room is dust-controlled.
• Humidity and temperature are maintained at acceptable levels.
• An ESD wrist strap is available.
EMI prevention
• A single-phase three-wire power receptacle with protection earth
(PE) is available for filtering interference from the power grid.
• The router is far away from radio transmitting stations, radar
stations, and high-frequency devices.
• Electromagnetic shielding, for example, shielded interface cables,
is used as required.
Ruler
Wire-stripping pliers
Rubber hammer
Drill MarkerDiagonal pliers
Flathead screwdriver
Phillips screwdriver
ESD wrist strap

HP FlexNetwork MSR 954 Specifications

General

Brand	HP
Model	FlexNetwork MSR 954
Category	Network Router
Language	English