B–4 User Guide
Technical Specifications
Entering User Modes
The video controller signal may occasionally call for a mode that
is not preset if:
■ You are not using a standard graphics adapter.
■ You are not using a preset mode.
If this occurs, you may need to readjust the parameters of the
monitor screen by using the on-screen display. Your changes can
be made to any or all of these modes and saved in memory. The
monitor automatically stores the new setting, then recognizes the
new mode just as it does a preset mode. In addition to the 18
factory preset modes, there are four user modes that can be
entered and stored.
Energy Saver Feature
When the monitor is in its normal operating mode, the monitor
uses less than 55 watts of power and the Power light is green.
The monitor also supports a reduced power state. The reduced
power state will be entered into if the monitor detects the absence
of either the horizontal sync signal and/or the vertical sync signal.
Upon detecting the absence of these signals, the monitor screen is
blanked, the backlight is turned off, and the Power light is turned
16 1280 x 1024 91.2 85.0
17 1600 x 1200 75.0 60.0
*18 1600 x 1200 93.8 75.0
* For analog inputs only.
Factory Preset Display Modes (Continued)
Preset Pixel Format Horz Freq (kHz) Vert Freq (Hz)
To Next Page
Loading...
Need help?
General
