Example 1 Displaying IGMP status for a VLAN
HP Switch(config)# show ip igmp vlan 1
IGMP Service Protocol Info
Total VLANs with IGMP enabled : 30
Current count of multicast groups joined : 20
VLAN ID : 2
VLAN Name : VLAN2
IGMP version : 2
Querier Address : 10.255.128.2
Querier Port : 1
Querier UpTime : 1h 51m 59s
Querier Expiration Time : 2min 5sec
Ports with multicast routers: 1, 5-6
Active Group Addresses Type Expires Ports Reports Queries
---------------------- --------- ----------- ------ ------- -------
226.0.6.7 Filter 2min 5sec 1 10 10
226.0.6.8 Standard 3min 20sec 2 20 20
Viewing the current IGMP configuration
Syntax:
show ip igmp config
Displays IGMP configuration for all VLANs on the switch.
Syntax:
show ip igmp vlan <vid> config
Displays IGMP configuration for a specific VLAN on the switch, including per-port
data.
For IGMP operating status, see the section "Internet Group Management Protocol (IGMP) status"
in the chapter "Monitoring and Analyzing Switch Operation" of the Management and Configuration
Guide for your switch.
Example:
Suppose you have the following VLAN and IGMP configurations on the switch:
QuerierIGMP enabledVLAN nameVLAN ID
NoYesDEFAULT_VLAN1
YesYesVLAN-222
YesNoVLAN-333
You could use the CLI to display this data as follows:
Configuring and displaying IGMP (CLI) 9
To Next Page
Need help?
General
